14 gauge speaker wire mac#

The dude from Silversmith cables employs the electromagnetic wave theory. In a metal conductor that speed is less than lightspeed in a vacuum.so, what’s your pleasure? Speakers are driven by electrons? By current? By voltage? By photons? The reason for that is electromagnetic waves are comprised of photons, which makes sense since photons are the only thing that can travel at lightspeed. But as we know electromagnetic waves travel at speed of light. People often believe the signal is an electromagnetic wave. Many folks believe current travels through conductors.

14 gauge speaker wire mac#

The 926 are certainly fine speakers but I found the Revel Performa3 F206 to be a serious notch above those with a MAC MA5200, for around the same money.Įverything is topsy turvy. depending, of course, on your sound room dimensions, acoustics, etc. You won't regret it! I've spent serious seat-time with a MAC MA5200 and a pair of those and that is a marriage made in heaven. If you can swing it, go for the Focal Aria 936. Here's just one of many, many charts to give you a basic idea about wire gauge: on audio forums before, you should be aware that the quickest way to start a fight in an empty bar is to start a forum or debate about cables, wire and interconnects. If you haven't already seen the eternal back & forth debates about speaker cables, interconnects, etc. Thirty or thirty five foot high quality, even reasonably priced, speaker cables are going to cost a lot of dough! However, if you want to spring for stuff like that, check out what your local audio shops might be able to offer or any of the fine, reputable on-line sellers (e.g. IMO, they are worth the miniscule and negligible extra effort. As far as I'm concerned, good quality soldered connections are the way to go. I've used bananas and non-soldered connectors in the past. I prefer soldered high-quality spades on both ends. Although I think you'd be fine with 14 gauge for the 35' run(s) you are contemplating, I think you'd get a little more oomph with a higher gauge, like that 12 gauge someone suggested. Make that length(s) as short as necessary. Make sure your speaker cables or wire-runs to each speaker are of equal length(s), even if one doesn't need to be as long as the other. Assuming you are setting up a strictly 2 channel system, I would recommend the following: